Diemazz

The term caliber (or calibre) designates the inside diameter of a tube, the diameter (outside) of a solid wire or rod, or a measurement of the length of a gun relative to its diameter.

The term most often appears with respect to firearms, as a measure of the inside diameter of the barrel in inches (or hundredths of an inch) or in millimetres.

Firearms

In firearms, the caliber is the approximate diameter of the bullet used. In a rifled barrel, the distance is measured between opposing lands or grooves; groove measurements are common in cartridge designations originating in the United States, while land measurements are more common elsewhere. This is very important when handloading, as the bullet should closely match the groove diameter of the barrel to ensure a good seal.

When the barrel diameter is given in inches, the abbreviation "cal" is used in place of "inches." For example, a (small bore) rifle with a diameter of 0.22 inch is a .22 cal; however, the decimal point is generally dropped when spoken, making it "twenty-two caliber."

Calibers of weapons can be referred to in millimeters, as in a "caliber of eighty-eight millimeters" (88 mm) or "a hundred and five-millimeter caliber gun" (often abbreviated as "105 mm gun").

While modern cartridges and cartridge firearms are generally referred to by the cartridge name, they are still lumped together based on bore diameter. For example, a firearm might be described as a .30 caliber rifle, which could be any of a wide range of cartridges using a roughly .30 inch projectile; or a .22 rimfire, referring to any rimfire cartridge using a .22 caliber projectile.

Cartridge naming conventions

Makers of early cartridge arms had to invent methods of naming^[1] the cartridges, since there was at the time no established convention. One of the early established cartridge arms was the Spencer repeating rifle, which saw service in the American Civil War. It was named based on the chamber dimensions, rather than the bore diameter, with the earliest cartridge called the "No. 56 cartridge," indicating a chamber diameter of .56 inch; the bore diameter varied considerably, from .52 to .54 inch. Later various derivatives were created using the same basic cartridge but with smaller diameter bullets; these were named by the cartridge diameter at the base and mouth. The original No. 56 became the .56-56, and the smaller versions, .56-52, .56-50, and .56-46. The .56-52, the most common of the new calibers, used a .50 caliber bullet.

Other early black powder-era cartridges used a similar naming scheme, but measured entirely different characteristics. This scheme was far more popular and was used into the advent of early smokeless powder cartridges. The cartridge would be described by the bullet diameter, in hundredths of an inch, and the powder charge in grains. Some of these cartridges remain popular today, such as the .45-70, .44-40, and .30-30 Winchester.

With the growing number of cartridges chambered for new smokeless powders, the cartridges started to be named based on bullet diameter combined with some other identifier. The .30-03 and .30-06 were named for the dates of introduction, 1903 and 1906, respectively. The .45 ACP, or .45 Automatic Colt Pistol, described the developer and intended use. Other times, some liberties are taken with the bullet diameter to differentiate different cartridges; for example, the .221 Fireball, .222 Remington, and .223 Remington all use the same bullet diameter, but the cartridges are different lengths. Some cartridges use a relative length in the name, such as .22 Short and .22 Long; or a relative power, such as .44 Special and .44 Magnum. Variations on these methods persist today, with new cartridges such as the .204 Ruger and .17 HMR (Hornady Magnum Rimfire).

Metric calibres for small arms are usually expressed with an "x" between the width and the length; for example, 7.62x51 NATO. This indicates that the cartridge uses a 7.62 mm diameter bullet, loaded in a case 51 mm long. Similarly, the 6.5x55 Swedish cartridge has a bullet of 6.5 mm and a case length of 55 mm. The means of measuring a rifled bore varies, and may refer to the diameter of the lands or the grooves of the rifling; this is why the .303 British, measured across the lands, actually uses a .311 inch bullet (7.70 mm vs. 7.90 mm), while the .308 Winchester, while dimensionally similar to (but should not be considered interchangeable with) the 7.62x51 mm NATO cartridge, is measured across the grooves and uses a .308" diameter (7.62 mm) bullet. An exception to this rule are the proprietary cartridges used by U.S. maker Lazzaroni, which are named based on the groove diameter in millimeters, such as the 7.82 Warbird.^[1][2]

Modern small arms range in bore size from approximately .17 (4.5 mm) up to .50 caliber (12.7 mm). Arms used to hunt large dangerous game, such as those used in express rifles, may be as large as .80 caliber. In the middle of the 19th century, muskets and muzzle-loading rifles were .58 caliber or larger; the Brown Bess flintlock, for example, had a bore diameter of about .75 caliber (19 mm). Paintball guns (or "markers") are typically .68 caliber (17 mm).

Caliber as measurement of length

Relationship of caliber in bore and length of gun.

The length of the barrel (especially for larger guns) is often quoted in calibers. The effective length of the barrel (from breech to muzzle) is divided by the barrel diameter to give a value. As an example, the main guns of the Iowa class battleships can be referred to as 16"/50 caliber. They are 16 inches in diameter and the barrel is 800 inches long (16 x 50 = 800). This is also sometimes indicated using the prefix L/; so for example, the most common gun for the Panzer V tank is described as a "75 mm L/70," meaning a barrel 75 mm in diameter, and 5250 mm long.

The practical effect of long barrels for modern guns is that the projectile spends more time in the barrel before it exits, and hence more time is available for expanding gasses from the propellant charge to accelerate the projectile, bringing about a higher velocity without placing undue strain on the gun. A longer barrel allows more propellant to be used, and ideally all the propellant should be combusted just before the projectile exits, to achieve maximum muzzle velocity.

Early gun barrels were short and thick, typically no more than 26 calibres, as the gunpowder propellant they used burned very quickly and violently, and hence its acceleration time was short. The new 20th century slow-burning propellants such as cordite and nitrocellulose allowed a gentler prolonged acceleration, hence gun barrels were made progressively longer and thinner. Mvelocity was then only limited by the length of barrel the construction methods of the day allowed.

Advanced technology is necessary to design and build long gun barrels which are strong enough to withstand the forces involved in accelerating the shell to a high velocity, while remaining light enough to be reasonably mobile, rigid enough to maintain accuracy, and having a bore able to withstand many firings before needing refurbishment. In World War I 45 calibre naval gun barrels were typical, in World War II 50 - 55 calibre barrels were common, with Germany already manufacturing tank guns of 70 calibres by 1943. Today 60 - 70 calibre barrels are not uncommon, but the latest technology has allowed shorter barrels of 55 calibres to attain muzzle velocities of 5,700 feet/second, as with the Rheinmetall 120 mm tank gun.

However, such relatively low calibre ratings for modern high-velocity guns can be misleading, as many such guns fire projectiles which are much smaller than the gun bore, and relatively light, using discarding sabots while in the barrel, and hence if we were to divide the gun bore length by the actual projectile diameter we would have a number of 60 - 70 calibres. Similarly, modern high-explosive filling is far more powerful than that used in the early 20th century, resulting in lighter shells being fired for a set bore diameter compared to 100 years ago, giving higher muzzle velocity for a given barrel calibre length without sacrificing firepower.

Alternative measurements of bore

Measurement of the bore of large weapons was often expressed in pounds. The weapon would be named according to the weight of a sphere of lead of the same diameter as the bore. The density of lead was used because it is a traditional material for projectiles.

This leads to certain guns being referred to as 6-pounder, 25-pounder, and so forth. However, this relationship between calibre and projectile weight changed with the introduction of the cylindrical rifled shell. The gun continued to be named by the weight of projectile it threw, although this no longer gave a direct indication of the barrel size.

Shotguns are named according to gauge, a related expression. The gauge of a shotgun refers to how many lead spheres the diameter of the bore would equal a pound. In the case of a 12-gauge shotgun, it would take twelve spheres the size of the shotgun's bore to equal a pound. Counterintuitively, a numerically larger gauge indicates a smaller barrel: a 20-gauge shotgun requires more spheres to equal a pound; therefore, its barrel is smaller than the 12 gauge. This metric is used in Russia as "caliber number": e.g., "shotgun of the twelve caliber." The sixteenth caliber is known as "lordly" (Russian: барский). While shotgun bores can be expressed in calibers (the .410 bore shotgun is in fact a caliber measure of .41 caliber [11 mm]), the nature of shotshells is such that the barrel diameter often varies significantly down the length of the shotgun barrel, with various levels of choke and backboring.

Metric versus inch

The following table lists some commonly used calibers with their metric and inch equivalents. Some calibers appear more than once; due to variations in naming conventions, as well as whims of the creator of various cartridges, bullet diameters can vary quite widely from the diameter implied by the name. For example, the .38 caliber cartridges in particular vary quite a bit, covering a range of approximately 0.045 inches (1.15 mm) from smallest to largest bullet diameter.

Calibers outside the range of .17 to .50 (4.5 to 12.7 mm) do exist, but are rarely encountered. Wildcat cartridges, for example, can be found in .10, .12, and .14 caliber (2.5, 3.0, & 3.6 mm), typically used for short range varmint hunting, where the high velocity, lightweight bullets provide devastating terminal ballistics with little risk of ricochet. Larger calibers, such as .577, .585, .600, .700, and .729 (14.7, 14.9, 15.2, 17.8, & 18.5 mm) are generally found in proprietary cartridges chambered in express rifles or similar guns intended for use on dangerous game.^[7]

Aviation bombs

Some countries (the former USSR and Russian Federation, for instance) use the "caliber" term to classify aviation bombs. The Russian/Soviet bomb caliber is expressed in mass/weight units, but may not be equal to the mass/weight of the munition.

Other uses

• In architecture, the caliber of a column is its diameter.
• In electricity, the caliber of an instrument of measure is the maximum value it can measure.
• In nautical parlance, the caliber of a chain is the diameter of the metal rod used to make each chain link.
• In agriculture, produce is also often ranked by caliber (diameter); for instance, olives, peas, or eggs.
• In typography, the caliber of a font designates the size of the eye of a character, neglecting any risers or descenders.
• In horology, the term is used to distinguish the size and type of movement used within a timepiece.
• In medicine, the caliber of a tube in the body (for example, the colon) is its diameter.
• Colloquially, the term "high caliber" is used to refer to people or employees of great competence or ability.

See also

• Gauge
• List of cartridges by caliber
• List of handgun cartridges
• List of rifle cartridges

References

Site Map: RSS 2.0

Recent Searches: Curia regis
new york stock exchange holidays
Regret (emotion)
Pentapolis
Carlos Slim Hel¡§
how to cook tapioca
Acronym Institute for Disarmament Diplomacy
List of ICD 9 codes 290 319: Mental disorders
Shake Station
cox s bazar beach

Related Pages:
"dodge caliber"
"50 caliber"
"45 caliber"
"caliber collision"
"17 caliber rifle"
"22 caliber"
"pro caliber motorsports"
"caliber srt4"
"380 caliber handgun"
"bullet caliber comparison chart"